> > >

Flood control water pump _Submersible pump

Roll over image to zoom in

1、We accept T/T，and 30% as the deposit，the balance payment should be paid before shipping.
2、We accept albaba credit guarantee payment.
3、We accept bank wire payment.

Description

Parametric

Service

Fault	Cause	Troubleshooting method
Water pump does not discharge water	1.No or insufficient liquid storage is added to the pump casing	1.Add enough liquid storage
	2. Air leakage in the suction pipeline	2.Check and eliminate air leakage phenomenon
	3. The speed is too low	3.Adjusting the speed
	4. The suction head is too high or the suction pipeline is too long	4.Reduce suction head or shorten suction pipeline
	5. Excessive mechanical seal leakage	5.Repair or replace
	6.The gas in the suction pipeline cannot be discharged from the outlet	6.Discharge the gas
Excessive noise and vibration	1.Unstable footing	1.Reinforce the footing
	2.Pump shaft bending	2.Replace or correct
	3.Cavitation	3.Adjusting working conditions
	4.Severe bearing wear	4.Replace it
	5.There are debris in the inlet pipeline	5.Remove debris
	6.The main shafts of the pump and engine are not concentric	6.Adjusting coaxiality
Insufficient water output	1.The impeller channel and suction pipe are blocked	3.Insufficient power or low speed
	2.Impeller or impeller seal severely worn	2.Replace the impeller or impeller seal
	3.Insufficient power or low speed	3.Add sufficient power and adjust to the rated speed
Excessive shaft power consumption	1.Excessive water flow rate	1.Increase outlet pressure
	2.Speed too high	2.Reduce appropriately
	3.Pump shaft bending or impeller jamming	3.Transformation or correction
	4.The flow channel inside the pump is blocked or stuck	4.Remove blockages