山东华全动力股份有限公司
山东华全动力股份有限公司
Description
Parametric
Service
The ZW series self suction sewage pump is mainly composed of a pump body, impeller, pump cover, bearing body, pump shaft, inlet valve, add water bolt, etc.
| Self-priming Sewage Pump Technical Parameters: | |
| Brand/Origin: Huaquan/Shandong | Medium: Sewage |
| Pump Type: Self-priming Pump | Shaft Power: 68 kW |
| Pump Model: ZW300-800-20 | Suction Lift: 4-6 m |
| Rated Head: 20m | Inlet Diameter: 300 mm |
| Rated Flow Rate: 800m³/h | Outlet Diameter: 250mm |
| Diesel Engine Technical Parameters | |
| Brand/Origin: YC/Guangxi | Cooling Method: Closed-loop Water Circulation Cooling |
| Diesel Engine Model: YC4A140L-D20 | Fuel Supply Method: Direct Injection |
| Diesel Engine Rated Power: 95kW | Diesel Engine Overload Power:105kW |
| Displacement: 4.84L | Speed Control Method: Electronic Speed Regulation |
| Number of Cylinders/Engine Structure: 4/L-type | Intake Method: Turbocharged |
| Bore and Stroke: 108×132mm | Overload Capacity: 110% |
| Starting Method: DC 24V electric start | Rated Speed: 1500 rpm |
Self suction pumps are suitable for urban environmental protection, construction, fire protection, chemical, pharmaceutical, printing and dyeing, brewing, electricity, electroplating, papermaking, industrial and mining flushing, equipment cooling, etc.
| Fault | Cause | Troubleshooting method |
| Water pump does not discharge water |
1.No or insufficient liquid storage is added to the pump casing | 1.Add enough liquid storage |
| 2. Air leakage in the suction pipeline | 2.Check and eliminate air leakage phenomenon | |
| 3. The speed is too low | 3.Adjusting the speed | |
| 4. The suction head is too high or the suction pipeline is too long | 4.Reduce suction head or shorten suction pipeline | |
| 5. Excessive mechanical seal leakage | 5.Repair or replace | |
| 6.The gas in the suction pipeline cannot be discharged from the outlet | 6.Discharge the gas | |
| Excessive noise and vibration |
1.Unstable footing | 1.Reinforce the footing |
| 2.Pump shaft bending | 2.Replace or correct | |
| 3.Cavitation | 3.Adjusting working conditions | |
| 4.Severe bearing wear | 4.Replace it | |
| 5.There are debris in the inlet pipeline | 5.Remove debris | |
| 6.The main shafts of the pump and engine are not concentric | 6.Adjusting coaxiality | |
| Insufficient water output |
1.The impeller channel and suction pipe are blocked | 3.Insufficient power or low speed |
| 2.Impeller or impeller seal severely worn | 2.Replace the impeller or impeller seal | |
| 3.Insufficient power or low speed | 3.Add sufficient power and adjust to the rated speed | |
| Excessive shaft power consumption |
1.Excessive water flow rate | 1.Increase outlet pressure |
| 2.Speed too high | 2.Reduce appropriately | |
| 3.Pump shaft bending or impeller jamming | 3.Transformation or correction | |
| 4.The flow channel inside the pump is blocked or stuck | 4.Remove blockages |
Weifang, shandong province, China 中国 山东。潍坊
Shandong Huaquan Power Co., Ltd.
Permanent copyright
